Hyundai i-30: Body (Interior and Exterior)
Hyundai i30 (PD) 2018-2024 Service Manual / Body (Interior and Exterior)
- Specifications
- Special service tools
- Troubleshooting
- Fender
- Hood
- Repair procedures
- Hood Assembly
- Hood Insulator Pad
- Hood Weatherstrip
- Hood Latch Release Handle
- Hood Latch
- Tail Gate
- Repair procedures
- Tail Gate Assembly
- Tail Gate Trim
- Tail Gate Latch
- Tail Gate Lift
- Tail Gate Weatherstrip
- Fuel Filler Door
- Front Door
- Components and components location
- Repair procedures
- Front Door Trim
- Front Door Inside Handle
- Front Door Window Glass
- Front Door Module
- Front Door Outside Handle
- Front Door Latch
- Front Door Latch
- Front Door Belt Outside Weatherstrip
- Front Door Belt Inside Weatherstrip
- Front Door Side Weatherstrip
- Rear Door
- Components and components location
- Repair procedures
- Rear Door Trim
- Rear Door Inside Handle
- Rear Door Window Glass
- Rear Door Module
- Rear Door Outside Handle
- Rear Door Latch
- Rear Door Belt Outside Weatherstrip
- Rear Door Belt Inside Weatherstrip
- Rear Door Side Weatherstrip
- Body Side Molding
- Panorama sunroof
- Components and components location
- Repair procedures
- Movable Glass
- Front Glass
- Panorama Sunroof Deflector
- Roller Blind
- Panorama Sunroof Assembly
- Panorama Sunroof Frame Weatherstrip
- Panorama Sunroof Movable Glass Tilt Lever
- Mirror
- Cowl Top Cover
- Floor Console
- Crash Pad
- Components and components location
- Cluster Fascia Panel
- Crash Pad Garnish
- Crash Pad Lower Panel
- Steering Column Shroud Panel
- Crash Pad Side Cover
- Crash Pad Under Cover
- Glove Box Housing Cover
- Main Crash Pad Assembly
- Cowl Cross Bar Assembly
- Roof Trim
- Interior Trim
- Components and components location
- Door Scuff Trim
- Door Step Trim
- Cowl Side Trim
- Front Pillar Trim
- Center Pillar Trim
- Rear Transverse Trim
- Luggage Side Trim
- Rear Pillar Trim
- Rear Wheel House Trim
- Trunk Trim
- Windshield Glass
- Floor Carpet
- Front Bumper
- Rear Bumper
- Front Seat
- Front Seat Assembly
- Front Seat Shield Outer Cover
- Front Seat Shield Inner Cover
- Front Seat Back Cover
- Front Seat Cushion Cover
- Front Seat Frame Assembly
- Rear Seat
- Components and components location
- Rear Seat Assembly
- Rear Seat Back Cover
- Rear Seat Cushion Cover
- Rear Back Armrest
- Rear Seat Latch
- Front Seat Belt
- Rear Seat Belt
AEB Camera
Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the MFC unit cover (A)...
Specifications
Specifications
Items
Specification
Hood
Type
Rear hinged, stay rod type
Front Door
Construction
Front hinged, frame door construction
Regulator system
Wire drum type
Locking system
Pin-fork system
Rear Door
Construction
Front hinged, frame door construction
Regulator system
Wire drum type
Locking system
Pin-fork system
Tail Gate
Type
Front hinged, gas lifter type
Seat Belts
Front
3 point type with Emergency Locking Retractor (E...
Other information:
Hyundai i30 (PD) 2018-2024 Service Manual: Rear Cross Member
Repair procedures Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securelysupported. 2. Remove the rear wheel and tire (A) from the rearhub...
Hyundai i30 (PD) 2018-2024 Owner's Manual: Mounting bracket for roof carrier
To install or remove a roof carrier, you can use the mounting bracket and cover on the roof. When you install a roof carrier, use the following procedure. 1. Insert a slim tool(coin or flat blade driver) into the slot and slide the cover toward the arrow on the cover...
Categories
- Manuals Home
- 3rd Generation i30 Owners Manual
- 3rd Generation i30 Service Manual
- Cruise control
- FCA sensor
- Front windscreen wiper service position
- New on site
- Most important about car
Bonnet
Opening the bonnet
1. Park the vehicle and set the parking brake.
2. Pull the release lever to unlatch the bonnet. The bonnet should pop open slightly.
Copyright © 2024 www.hi30.net