Hyundai i-30: Rear Seat Belt / Rear Seat Belt Buckle
Components and components location

1. Rear seat
belt buckle [RH]
2. Rear seat belt buckle [LH]
|
3. Rear center
seat belt buckle
|
Repair procedures
1. |
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Cushion Assembly")
|
2. |
Remove the rear seat back cover [RH].
(Refer to Rear Seat - "Rear Seat Back Cover")
|
3. |
Disconnect the connector (A) and then remove the rear seat belt buckle
(B).
[LH, Center]
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)
|

[RH]
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)
|

|
4. |
To install, reverse removal procedure.
• |
The buckle and tongue of different types are impossible
to be latched, so check that the buckle & tongue have
the same types.
|
• |
Distinguish the rear side seat buckle from the center
seat buckle before latching.
|
• |
If foreign materials are stuck in the inside button
of buckle, it may cause interference during the latching
process, leading to a functional problem (for example-
beverages (viscous drinks), toothpicks, sand, plastic,
vinyl, metal pieces, etc.).
|
• |
After latching the buckle and tongue, check the fastening
force using a Push-Pull Gauge (fastening force: 3kgf
or less).
|
|
|
Components and components location
Component Location
1. Rear center
seat belt retractor
Repair procedures
Replacement
•
When installing the belt, make sure not to damage the retractor...
Other information:
Components and components location
Component Location
1. Cowl cross
bar assembly
Repair procedures
Replacement
•
Put on gloves to prevent hand injuries...
Basic Service Symbols
There are five primary symbols used to complement illustrations. These symbols
indicated the materials to be applied to parts during service.
Symbol
Meaning
Do not reuse the part...
Categories
Seat belt warning
Driver’s seat belt warning

■ Instrument cluster
As a reminder to the driver, the seat
belt warning light will illuminate for
approximately 6 seconds each time
you turn the ignition switch ON
regardless of belt fastening.
read more