Troubleshooting |
Symptom |
Passible Cause |
Remedy (Refer to page) |
Water leaks from panorama sunroof |
Deteriorated roof lid weatherstrip |
Replace |
Excessive roof lid-to-body clearance and improperly fitted weatherstrip |
Adjust |
|
Wind noise around Panorama sunroof |
Loose or deformed deflector, gaps in body work |
Retighten adjust or replace |
Noise created by moving panorama sunroof lid |
Foreign particles lodged in guide rail |
Check drive cable and guide rails for foreign particles |
Loose guide rails and lid |
Retighten |
|
Motor runs but sunroof does not move or moves only partially |
Foreign particles lodged in guide rail |
Adjust or replace |
Incorrect engagement of motor pinion with drive cable |
||
Decrease in motor's clutch slipping force |
||
Increased sunroof sliding resistance or interference of sunroof with drive
cables, weatherstrip, etc. due to abnormal adjustment of sunroof |
||
Noise in motor (clutch slipping noise from motor when sunroof is fully opened
or closed) is considered as normal |
Incorrect engagement of motor pinion with drive cable |
Check pinion installation and Re-tighten motor |
Worn out or damaged motor pinion bearing |
Replace motor assembly |
|
Worn out or deformed drive cable |
Replace |
|
Door glass fails to operate up and down |
Incorrect window glass installation |
Adjust position |
Damaged or faulty regulator arm or regulator |
Correct or replace |
|
Door does not open or close completely |
Incorrect door installation |
Adjust position |
Defective door check assembly |
Correct or replace |
|
Door hinge requires grease |
Apply grease |
|
Hood does not open or close completely |
Striker and latch not properly aligned |
Adjust |
Incorrectly installed hood |
Adjust |
|
Incorrect hood bumper height |
Adjust |
|
Water leaks through windshield and rear window |
Defective seal |
Fill with sealant |
Defective flange |
Correct |
Seat belt warning
Driver’s seat belt warning
■ Instrument cluster
As a reminder to the driver, the seat belt warning light will illuminate for approximately 6 seconds each time you turn the ignition switch ON regardless of belt fastening.