Hyundai i-30: Fender / Components and components location
Replacement
•
When removing the fender, wrap protective tape around a screwdriver
or remover not to damage components
•
Put on gloves to prevent hand injuries
•
When removing the clips, use a clip remover...
Other information:
Lighting control
To operate the lights, turn the knob at
the end of the control lever to one of
the following positions:
(1) O (OFF) position
(2) AUTO light position (if equipped)
(3) Position lamp position
(4) Headlamp position
AUTO light position
When the light switch is in the AUTO
position, the position lamp and headlamp
will be turned ON or OFF automatically
depending on the amount
of light outside the vehicle...
You can check the tyre pressure in
the Assist mode on the cluster.
Refer to the "LCD Display
Modes" in chapter 3.
Tyre pressure is displayed after a
few minutes of driving after initial
engine start up.
If tyre pressure is not displayed when
the vehicle is stopped, "Drive to display"
message will appear...
Categories
To signal a turn, push down on the
lever for a left turn or up for a right
turn in position (A). To signal a lane
change, move the turn signal lever
slightly and hold it in position (B).The
lever will return to the OFF position
when released or when the turn is
completed.
read more