Hyundai i-30: Rear Seat / Rear Seat Cushion Cover
Components and components location
1. Rear seat
cushion cover
|
|
Repair procedures
•
|
Put on gloves to prevent hand injuries.
|
|
•
|
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
•
|
When removing the interior trim pieces, use a plastic panel
removal tool not to damage the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Remove the seat assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
|
2. |
After removing the Velcro tape (A) and hog-ring clips (B) inside the
rear seat cushion cover, remove the seat cushion cover (C).
[Front side]
[Rear side]
|
3. |
To install, reverse removal procedure.
• |
Make sure that the connectors are connected completely.
|
• |
Replace any damaged clips (or pin-type retainers).
|
• |
To prevent wrinkles, make sure that the cover (B) is
stretched evenly before connecting the hog-ring clips
(A).
|
• |
Replace the hog-ring clips with new ones using special
tool (C) (09880-4F000).
|
|
|
Components and components location
Component Location
1. Rear seat
back cover [LH]
2. Rear seat
back cover [RH]
Repair procedures
Replacement
[LH]
•
Put on gloves to prevent hand injuries...
Repair procedures
Replacement
•
When prying with a flat-tip screwdriver or use a prying trim
tool, wrap it with protective tape, and apply protective tape
around the related parts, to prevent damage...
Other information:
Schematic diagrams
Circuit Diagram
[Driver power seat switch]
Repair procedures
Inspection
Seat Control Switch
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below...
..
Categories
Operating door locks from
outside the vehicle
Mechanical key
Turn the key toward the rear of the
vehicle to unlock and toward the front
of the vehicle to lock.
If you lock/unlock the driver's door
with a key, a driver’s door will
lock/unlock automatically.
read more