Hyundai i-30: Hood / Hood Insulator Pad
Repair procedures
1. |
Using a clip remover, remove the clips and then the hood insulator pad
(A).
• |
Be careful not to scratch the hood panel.
|
|

|
2. |
To install, reverse removal procedure.
• |
Replace any damaged clips (or pin-type retainers).
|
|
|
Components and components location
Component Location
1. Hood assembly
Repair procedures
Replacement
•
Be careful not to damage the hood and body...
Repair procedures
Replacement
1.
Remove the hood weatherstrip (A).
•
Be careful not to scratch the hood weatherstrip...
Other information:
Troubleshooting
Symptom
Passible Cause
Remedy (Refer to page)
Water leaks from panorama sunroof
Deteriorated roof lid weatherstrip
Replace
Excessive roof lid-to-body clearance and improperly fitted weatherstrip
Adjust
Wind noise around Panorama sunroof
Loose or deformed deflector, gaps in body work
Retighten adjust or replace
Noise created by moving panorama sunroof lid
Foreign particles lodged in guide rail
Check drive cable and guide rails for foreign particles
Loose guide rails and lid
Retighten
Motor runs but sunroof does not move or moves only partially
Foreign particles lodged in guide rail
Adjust or replace
Incorrect engagement of motor pinion with drive cable
Decrease in motor's clutch slipping force
Increased sunroof sliding resistance or interference of sunroof with drive
cables, weatherstrip, etc...
Components Location
1. ECM (Engine
Control Module)
2. Mass Air Flow Sensor (MAFS)
3. Manifold Absolute Pressure Sensor (MAPS)
4. Intake Air Temperature Sensor (IATS)
5. Boost Pressure Sensor (BPS)
6...
Categories
Opening the bonnet

1. Park the vehicle and set the parking
brake.
2. Pull the release lever to unlatch
the bonnet. The bonnet should
pop open slightly.

read more