Hyundai i-30: Rear Door / Rear Door Outside Handle
Components and components location
1. Rear door
outside handle
|
|
Repair procedures
1. |
Remove the plug hole (B).
|
2. |
After loosening the mounting bolt, remove the rear door outside handle
cover (A).
Tightening torque :
7.8 - 10.8 N.m (0.8 - 1.1 kgf.m, 5.8 - 8.0 lb-ft)
|
|
3. |
Remove the rear door outside handle (A) by pushing it in the direction
of arrow.
|
4. |
To install, reverse removal procedure.
• |
Make sure the door locks / unlocks and opens / closes
properly.
|
• |
Be sure to install the outside handle pad (A) between
the outside handle and the door panel.
|
|
|
Components and components location
Component Location
1. Rear door
module
Repair procedures
Replacement
1...
Components and components location
Component Location
1. Rear door
latch
Repair procedures
Replacement
1...
Other information:
Repair procedures
Hub nut tightening sequence
1.
Tighten the hub nuts as follows.
Tightening torque :
107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)
•
When using an impact gun, final tightening torque should
be checked using a torque wrench...
Repair procedures
Inspection
1.
Disconnector the negative (-) battery terminal.
2.
Remove the overhead console lamp.
(Refer to Body Electrical System - "Overhead Console Lamp")
3...
Categories
When the High Beam Assist (HBA)
System is not working properly, the
warning message will come on for a
few second. After the message disappears,
the master warning light ()
will illuminate.
read more