Hyundai i-30: Clutch Regulator / Repair procedures
[Gasoline 1.0 T-GDI]
1. |
Remove the snap pins (A) and the regulator (B).
• |
Do not spill brake fluid on the vehicle it may damage
the paint if brake fluid does contact the paint, wash
it off immediately with water.
|
|

|
[Diesel 1.6 TCI]
1. |
Disconnect the clutch tube (A) and then removing the snap pin (B).
Tightening torque :
(A): 12.7 - 16.7 N.m (1.3 - 1.7 kgf.m, 9.4 - 12.3 lb-ft)
|
|
2. |
Remove the regulator (C).
• |
Do not spill brake fluid on the vehicle it may damage
the paint if brake fluid does contact the paint, wash
it off immediately with water.
|
|

|
1. |
To install, reverse the removal procedures.
|
2. |
Perform bleeding air procedure in concentric slave cylinder after pouring
the brake fluid.
(Refer to Clutch System - "Concentric Slave Cylinder Assembly")
|
Components
[Gasoline 1.0 T-GDI]
1. Clutch pedal assembly
2. Clutch pedal arm
3. Ignition lock & clutch switch
4...
Other information:
Components and components location
Components
1. Radiator assembly
2. Mounting insulator
3. Radiator upper mounting bracket
4. Radiator upper
hose
5. Radiator lower hose
6. Filler neck assembly
Repair procedures
Removal and Installation
1...
Consult a HYUNDAI authorised
repairer to replace most vehicle light
bulbs. It is difficult to replace vehicle
light bulbs because other parts of the
vehicle must be removed before you
can get to the bulb. This is especially
true for removing the headlamp
assembly to get to the bulb(s)...
Categories
If your vehicle is equipped with a
sunroof, you can slide or tilt your
sunroof with the sunroof control lever
located on the overhead console.

The ignition switch must be in the ON
position before you can open or
close the sunroof.
The sunroof can be operated for
approximately 30 seconds after the
ignition key is removed or turned to
the ACC or LOCK(or OFF) position.
However, if the front door is opened,
the sunroof cannot be operated even
within 30 seconds.
read more