Hyundai i-30: Front Seat Belt / Front Seat Belt Pretensioner
Components and components location

1. Front seat
belt pretensioner
|
|
Repair procedures
| •
|
When installing the belt, make sure not to damage the pretensioner.
|
|
|
1. |
Remove the center pillar upper trim.
(Refer to Interior Trim - "Center Pillar Trim")
|
|
2. |
After loosening the front belt upper anchor mounting bolt, remove the
front belt upper anchor (A).
|
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)
|

|
|
3. |
Disconnect the front seat belt pretensioner connector (A).

|
|
4. |
Loosen the mounting bolt and remove the front belt retractor (A).
|
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)
|

|
|
5. |
To install, reverse removal procedure.
|
• |
After installing the front seat belt retractor, check
that the air bag warning indicator illuminates for about
6 seconds when the ignition is ON and then goes out.
|
|
• |
Make sure the connector is plugged in properly.
|
|
• |
Replace any damaged clips (or pin-type retainers).
|
|
|
Components and components location
Component Location
1. Height adjust
Repair procedures
Replacement
1...
Other information:
Components and components location
Components Location
1. Condenser
Repair procedures
Inspection
1.
Check the condenser fins for clogging and damage. If clogged, clean
them with water, and blow them with compressed air...
Description and operation
Description
The photo sensor is located at the center of the defrost nozzles.
The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The
solar radiation received by its light receiving portion, generates an electromotive
force in proportion to the amount of radiation received which is transferred
to the automatic temperature control module so that the solar radiation compensation
will be performed...
Categories
Speedometer

The speedometer indicates the
speed of the vehicle and is calibrated
in kilometers per hour (km/h) and/or
miles per hour (MPH).
Tachometer

read more