Hyundai i-30: Engine Control / Fuel System / Engine Control System
Hyundai i30 (PD) 2018-2024 Service Manual / Engine Control / Fuel System / Engine Control System
- Components and components location
- Description and operation
- Engine Control Module (ECM)
- Mass Air Flow Sensor (MAFS)
- ETC (Electronic Throttle Control) System
- Manifold Absolute Pressure Sensor (MAPS)
- Intake Air Temperature Sensor (IATS)
- Ambient Temperature Sensor (ATS)
- Boost Pressure Sensor (BPS)
- EGR Pressure Sensor
- Engine Coolant Temperature Sensor (ECTS)
- Crankshaft Position Sensor (CKPS)
- Camshaft Position Sensor (CMPS)
- Knock Sensor (KS)
- Heated Oxygen Sensor (HO2S)
- Accelerator Position Sensor (APS)
- Rail Pressure Sensor (RPS)
- Oil Pressure & Oil Temperature Sensor (OPTS)
- Injector
- Differential Pressure Sensor (DPS)
- Exhaust Gas Temperature Sensor (EGTS)
- Differential Pressure Valve (DPV)
- Purge Control Solenoid Valve (PCSV)
- Variable Force Solenoid (VFS)
- Electric WGT Control Actuator
- RCV Control Solenoid Valve
- Electric Exhaust Gas Recirculation (EEGR) Control Valve
- Thermal Management Module (TMM) Motor
- CVVD Actuator
- Fuel Pressure Control Valve (FPCV)
Troubleshooting
Basic Troubleshooting
Basic Troubleshooting Guide
Customer Problem Analysis Sheet
Basic Inspection Procedure
Measuring Condition of Electronic Parts'
Resistance
The measured resistance at high temperature after vehicle running may be high
or low...
Components and components location
Components Location
1. ECM (Engine
Control Module)
2. Mass Air Flow Sensor (MAFS)
3. Manifold Absolute Pressure Sensor (MAPS)
4...
Other information:
Hyundai i30 (PD) 2018-2024 Service Manual: Description and operation
Description The immobilizer system will disable the vehicle unless the proper ignition key is used, in addition to the currently available anti-theft systems such as car alarms, the immobilizer system aims to drastically reduce the rate of auto theft...
Hyundai i30 (PD) 2018-2024 Service Manual: Mass Air Flow Sensor (MAFS)
Description and operation Description MAFS uses a hot-film type sensing element to measure the mass of intake air entering the engine, and send the signal to ECM. A large amount of intake air represents acceleration or high load conditions while a small amount of intake air represents deceleration or idle...
Categories
- Manuals Home
- 3rd Generation i30 Owners Manual
- 3rd Generation i30 Service Manual
- Theft-alarm system
- Tyre pressure monitoring system
- Shift-lock system. Shift-lock release
- New on site
- Most important about car
Warning light and message
When the High Beam Assist (HBA)
System is not working properly, the
warning message will come on for a
few second. After the message disappears,
the master warning light (
)
will illuminate.
Copyright © 2024 www.hi30.net