Hyundai i-30: Engine Control System / Ambient Temperature Sensor (ATS)

Hyundai i30 (PD) 2018-2025 Service Manual / Engine Control / Fuel System / Engine Control System / Ambient Temperature Sensor (ATS)

Description and operation

Description

Ambient Temperature Sensor (ATS) is installed on the front-end module and senses the ambient temperature. ECM receives not only the intake air temperatue but also the ambient air temperature informations at the same time to control the intake air quantity precisely provided through the turbo charger. The electrical resistance of the thermistor decreases as the temperature increases, and increases as the temperature decreases This sensor has a Negative Temperature Coefficient (NTC) and its resistance is in inverse proportion to the temperature.

Specifications

Specification

Temperature [°C (°F)]	Resistance (kΩ)
-40 (-40)	841.2 - 1019.3
-20 (-4)	263.8 - 306.5
0 (32)	92.4 - 102.8
10 (50)	57.0 - 62.2
20 (68)	36.2 - 38.8
40 (104)	15.3 - 16.7
50 (122)	10.3 - 11.4
60 (140)	7.1 - 8.0
80 (176)	3.5 - 4.0

Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the ATS connector.

3.	Measure resistance between the ATS terminals 1 and 2 [B1/S1].

Check that the resistance is within the specification.

Specification : Refer to "Specification"

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the engine room under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover")

3.	Disconnect the ATS connector (A), and then removing the sensor (B).

Installation

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

1.	Install in the reverse order of removal.

Intake Air Temperature Sensor (IATS)

Description and operation Description Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature...

Boost Pressure Sensor (BPS)

Description and operation Description The Boost Pressure Sensor (BPS) is installed on the intercooler assembly and measures the pressure of the compressed air in turbocharger...

Other information:

Hyundai i30 (PD) 2018-2025 Owner's Manual: Anti-lock Brake System (ABS) Warning Light. Electronic Brake Force Distribution (EBD) System Warning Light. Electronic Parking Brake (EPB) Warning Light

Anti-lock Brake System (ABS) Warning Light This warning light illuminates: When you set the ignition switch or the Engine Start/Stop button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When there is a malfunction with the ABS (The normal braking system will still be operational without the assistance of the anti-lock brake system)...

Hyundai i30 (PD) 2018-2025 Owner's Manual: Front fog lamp

■ Type A ■ Type B 1. Loosen the pin-type retainers of the under cover and then remove the undercover. 2. Reach your hand into the back of the front bumper. 3. Disconnect the power connector from the socket. 4. Remove the bulb-socket from the housing by turning the socket counterclockwise until the tabs on the socket align with the slots of the housing...