Hyundai i-30: Heating, Ventilation and Air Conditioning / Heater
Components and components location
Component Location
1. Duct sensor
[Vent]
2. Duct sensor
[Floor]
Repair procedures
Inspection
1...
Components and components location
Component Location
1. Heater unit
assembly
Components
1...
Other information:
Repair procedures
Inspection
1.
Measure the resistance between the terminals.
2.
The measured resistance is not within specification, the blower resistor
must be replaced. (After removing the resistor)
Replacement
1...
The sensors are located inside the
rear bumper.
Always keep the rear bumper clean
for proper operation of the system.
Warning message
BCW (Blind-Spot Collision
Warning) system disabled.
Radar blocked
• This warning message may appear
when :
- One or both of the sensors on the
rear bumper is blocked by dirt or
snow or a foreign object...
Categories

When the High Beam Assist (HBA)
System is not working properly, the
warning message will come on for a
few second. After the message disappears,
the master warning light (
)
will illuminate.
read more