Hyundai i-30: Heating, Ventilation and Air Conditioning / Controller

Intake Actuator

Components and components location Components Location 1. Intake actuator Description and operation Description The intake actuator is located at the blower unit...

Heater & A/C Control Unit (Manual)

Components and components location Components Connector [A] Pin NO Function Pin NO Function 1 Low 4 Middle Low 2 Common 5 Middle High 3 Ground 6 High Connector [B] Pin NO Function Pin NO Function 1 Battery (+) 21 IGN2 2 ISG B+ 22 IGN1 3 ILL+ (TAIL) 23 - 4 Sensor REF (+5V) 24 - 5 Mode actuator feedback 25 - 6 Temperature actuator feedback 26 - 7 Intake actuator feedback 27 MAX Blower ON Signal 8 EVAP Sensor (+) 28 PTC Relay 3 9 AMB Sensor (+) 29 PTC Relay 2 10 Mode actuator (Vent) 30 PTC on signal 11 Mode actuator (Defrost) 31 Detent OUT (-) 12 Temperature actuator (Cool) 32 - 13 Temperature actuator (Warm) 33 C_CAN High 14 Intake actuator (Fresh Air) 34 C_CAN Low 15 Intake actuator (Recirculated Air) 35 - 16 HTD (Rear defog indicator) 36 ECV + 17 Rear defog switch 37 ECV- (Ground) 18 - 38 Sensor ground 19 Blower ON signal to common 39 Ground 20 ILL- (RHEO) 40 Ground Repair procedures Replacement 1...

Other information:

Hyundai i30 (PD) 2018-2025 Service Manual: Repair procedures

Replacement    • Put on gloves to prevent hand injuries.    • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

Hyundai i30 (PD) 2018-2025 Service Manual: Repair procedures

Inspection ESP System Bleeding This procedure should be followed to ensure adequate bleeding of air and filling of the ESC unit, brake lines and master cylinder with brake fluid. 1. Remove the reservoir cap and fill the brake reservoir with brake fluid...