Hyundai i-30: Interior features / Power outlet
■ Front • Type A
■ Front • Type B
■ Centre
■ Rear
The power outlet is designed to provide
power for mobile telephones or
other devices designed to operate
with vehicle electrical systems. The
devices should draw less than 180
W(Watt) with the engine running.
WARNING
Avoid electrical shocks. Do not
place your fingers or foreign
objects (pin, etc.) into a power
outlet or touch the power outlet
with a wet hand.
NOTICE
To prevent damage to the Power
Outlets :
- Use the power outlet only when
the engine is running and remove
the accessory plug after use.
Using the accessory plug for prolonged
periods of time with the
engine off could cause the battery
to discharge.
- Only use 12V electric accessories
which are less than 180 W(Watt) in
electric capacity.
- Adjust the air-conditioner or
heater to the lowest operating
level when using the power outlet.
- Close the cover when not in use.
- Some electronic devices can
cause electronic interference
when plugged into a vehicle’s
power outlet.These devices may
cause excessive audio static
and malfunctions in other electronic
systems or devices used
in your vehicle.
- Push the plug in as far as it will
go. If good contact is not made,
the plug may overheat and the
fuse may open.
- Plug in battery equipped electrical/
electronic devices with reverse
current protection. The current
from the battery may flow into the
vehicle's electrical/electronic system
and cause system malfunction.
To use a sunvisor, pull it downward.
To use a sunvisor for a side window,
pull it downward, unsnap it from the
bracket (1) and swing it to the side (2)...
■ Type A
■ Type B
To use the cigarette lighter, the ignition
switch must be in the ACC or ON
position.
Push the cigarette lighter all the way
into its socket...
Other information:
Components and components location
Components
1. Remote control
switch (Audio swtich)
2. Remote control
switch (Cruise control switch)
Schematic diagrams
Circuit Diagram
TRIP / SCC / LFA
Repair procedures
Removal
1...
System setting
The driver can activate the Speed
Limit Warning by selecting 'User
Settings → Driver assistance →
Intelligent Speed Limit Warning'.
When the ISLW is activated, the
symbols appear on the instrument
cluster to display the speed limit
information and overtaking restriction...
Categories
When the High Beam Assist (HBA)
System is not working properly, the
warning message will come on for a
few second. After the message disappears,
the master warning light ()
will illuminate.
read more