Hyundai i-30: Manual heating and air conditioning / Air intake control
This is used to select the outside
(fresh) air position or recirculated air
position.
To change the air intake control position,
push the control button.
Recirculated air position
With the recirculated air
position selected, air from
the passenger compartment
will be drawn through
the heating system and
heated or cooled according
to the function selected.
Outside (fresh) air position
With the outside (fresh)
air position selected, air
enters the vehicle from
outside and is heated or
cooled according to the
function selected.
Information
Using the system in the fresh air position
is recommended.
Prolonged operation of the heater in
the recirculated air position (without
air conditioning selected) can cause
fogging of the windscreen and side
windows and the air within the passenger
compartment will become
stale.
In addition, prolonged use of the air
conditioning with the recirculated air
position selected will result in excessively
dry air in the passenger compartment.
WARNING
- Continued climate control
system operation in the recirculated
air position may allow
humidity to increase inside
the vehicle which may fog the
glass and obscure visibility.
- Do not sleep in a vehicle with
the air conditioning or heating
system on. It may cause serious
harm or death due to a
drop in the oxygen level
and/or body temperature.
- Continued climate control system
operation in the recirculated
air position can cause
drowsiness or sleepiness, and
loss of vehicle control. Set the
air intake control to the outside
(fresh) air position as much as
possible whilst driving.
The temperature will increase by
turning the knob to the right. The
temperature will decrease by turning
the knob to the left.
Adjusting the driver and passenger
side temperature equally
Press the “SYNC” button to adjust
the driver and passenger side temperature
equally...
Fan speed control
The fan speed can be set as desired
by pushing the fan speed control button.
More air is delivered with higher fan
speeds.
Pressing the OFF button turns off the
fan...
Other information:
1. Open the tailgate, and remove the
towing hook from the tool case.
■ Front
■ Rear
2. Remove the hole cover pressing
the lower part of the cover on the
bumper.
3. Install the towing hook by turning it
clockwise into the hole until it is
fully secured...
Components and components location
Components
Audio
Connector Pin Information
NO
Connector A
Connector B
1
Rear left speaker (+)
-
2
Front left speaker (+)
-
3
Front right speaker (+)
-
4
Rear right speaker (+)
Steering wheel key
5
-
-
6
Door open
USB data (HI)
7
IGN 1
USB VCC
8
ILL (+)
-
9
DETENT
-
10
Rear left speaker (-)
MIC signal (+)
11
Front left speaker (-)
ACC
12
Front right speaker (-)
Battery (+)
13
Rear right speaker (-)
-
14
-
-
15
-
-
16
-
Speed
17
ILL (-)
Steering wheel key GND
18
Antenna Power
USB data (LOW)
19
USB GND
20
-
21
-
22
MIC signal (-)
23
-
24
GND
Display Audio
Connector Pin Information
No
Connector A
Connector B
1
Rear door speaker (Left +)
-
2
Rear door speaker (Left -)
Mic_Signal (+)
3
USB Ground
-
4
USB Data_High
-
5
USB Data_Low
Antenna power
6
USB_VCC
Illumination (+)
7
Camera video
MM CAN (High)
8
-
-
9
-
-
10
AUX Audio R
Battery (+)
11
AUX Detect
Battery (+)
12
Steering wheel remote
Ground
13
Front door speaker (Left +)
Ground
14
Front door speaker (Left -)
Mic_Ground
15
Front door speaker (Right -)
Mic_Signal (-)
16
Front door speaker (Right +)
-
17
-
-
18
-
Vehicle speed
19
-
Illumination (-)
20
Camera power ground
MM CAN (Low)
21
Camera video ground
-
22
-
ACC
23
-
-
24
AUX Audio L
-
25
AUX Audio ground
-
26
Steering wheel remote grond
Door open
27
Rear door speaker (Right -)
-
28
Rear door speaker (Right +)
-
29
-
-
30
-
-
31
-
-
32
Camera power ground
IGN 1
33
Camera shield ground
-
34
-
-
35
-
-
36
Camera_Detect
37
-
38
-
Repair procedures
Removal
•
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components...