Hyundai i-30: Parking Distance Warning (PDW) / Specifications
Item
|
Specification
|
Ultrasonic sensor
|
Voltage rating
|
DC 12 V
|
Operation voltage
|
DC 9 - 16 V
|
Operation current
|
MAX 350 mA
|
Operation temperature
|
-22 - 116°F (-30 - 80°C)
|
Operation frequency
|
48 ± 5 KHz
|
Number of sensors
|
7 - 8 units
|
Component Location
1. BCM (Body
Control Module)
2. Ultrasonic
sensor
•
Rear parking assist control unit function is built in BCM (Body
Control Module)...
Other information:
Anti-lock Brake System
(ABS) Warning Light
This warning light illuminates:
When you set the ignition switch or
the Engine Start/Stop button to the
ON position.
- It illuminates for approximately 3
seconds and then goes off.
When there is a malfunction with
the ABS (The normal braking system
will still be operational without
the assistance of the anti-lock
brake system)...
Components and components location
Component Location
1. Ventilation
seat blower.
2. Ventilation
seat unit (Assist seat only).
Schematic diagrams
Circuit Diagram
Air Ventilation Unit Connector
No
Connecter A
Connecter B
Connecter C
1
Seat vent unit IGN 1
Driver vent switch led (Low)
vent / heater power
2
Driver blower power
Driver vent switch led (Mid)
Driver heater power
3
Driver blower speed
Driver vent switch led (High)
Driver heater ground
4
Driver RPM input
Driver NTC (+)
Driver / Assist, Vent / Heater ground
5
Driver heater switch
-
vent / heater power
6
Driver vent switch
Illumination (-)
-
7
Illumination (+)
Driver NTC (-)
Assist heater power
8
Driver heater LED (Low)
Driver blower ground
-
9
Driver heater LED (Mid)
Driver vent led (Low)
Assist heater ground
10
Driver heater LED (High)
Driver vent led (Mid)
Driver / Assist, Vent / Heater ground
11
Vent seat unit IGN 2
Driver vent led (High)
12
Assist blower power
Assist NTC (+)
13
Assist blower speed
-
14
Assist blower RPM input
-
15
Assist heater switch
Assist NTC (-)
16
Assist vent switch
Assist blower ground
17
Detent
18
Assist heater LED (Low)
19
Assist heater LED (Mid)
20
Assist heater LED (High)
Repair procedures
Removal
[Ventilation Blower]
1...
Categories
To signal a turn, push down on the
lever for a left turn or up for a right
turn in position (A). To signal a lane
change, move the turn signal lever
slightly and hold it in position (B).The
lever will return to the OFF position
when released or when the turn is
completed.
read more