Hyundai i-30: General Information / Special service tools

Hyundai i30 (PD) 2018-2025 Service Manual / Driveshaft and axle / General Information / Special service tools

Special Service Tools

Tool(Number and Name)	Illustration	Use
09495-3K000 Band installer		Installation of ear type boot band
09495-39100 Band installer		Installation of hook type boot band
09568-1S100 Ball joint puller		Saperate the ball joint from the front axle
09495-33000 Puller		Removal of spider assembly from a drive shaft

Specifications

Specification Engine Transaxle Joint type Max. permissible angle Outer Inner Outer Inner KAPPA 1...

Other information:

Hyundai i30 (PD) 2018-2025 Service Manual: General Service Information

General Service Information Protection of the Vehicle Always be sure to cover fenders, seats, and floor areas prior to beginning work. • The support rod must be inserted into the hole near the edge of the hood whenever you inspect the engine compartment to prevent the hood from falling and causing possible injury...

Hyundai i30 (PD) 2018-2025 Service Manual: Wheel

Repair procedures Hub nut tightening sequence 1. Tighten the hub nuts as follows. Tightening torque : 107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft) • When using an impact gun, final tightening torque should be checked using a torque wrench...

Categories

Panorama sunroof

If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control lever located on the overhead console.

Hyundai i30. Panorama sunroof

The ignition switch must be in the ON position before you can open or close the sunroof.

The sunroof can be operated for approximately 30 seconds after the ignition key is removed or turned to the ACC or LOCK(or OFF) position. However, if the front door is opened, the sunroof cannot be operated even within 30 seconds.