Hyundai i-30: What to do in an emergency / Hazard warning flasher
The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle.
It should be used whenever emergency repairs are being made or when the vehicle is stopped near the edge of a roadway.
To turn the hazard warning flasher on or off, press the hazard warning flasher button with the ignition switch in any position. The button is located in the centre fascia panel. All turn signal lights will flash simultaneously.
- The hazard warning flasher operates whether your vehicle is running or not.
- The turn signals do not work when the hazard flasher is on.
In case of an emergency whilst driving
If the engine stalls whilst driving
Reduce your speed gradually,
keeping a straight line. Move cautiously
off the road to a safe place.
Turn on your hazard warning flasher...
If the engine will not start
If the engine doesn't turn over
or turns over slowly
Be sure the shift lever is in N
(Neutral) or P (Park) if it is an automatic
transmission/dual clutch
transmission vehicle...
Other information:
Hyundai i30 (PD) 2018-2024 Service Manual: Emergency Fastening Device (EFD)
Components and components location Components 1. EFD (Emergency Fastening Device) System Description and operation Description The Emergency Fastening Device (EFD) operates at the same time with the Seat Belt Pretensioner when it satisifies the deployment condition after a collision...
Hyundai i30 (PD) 2018-2024 Service Manual: General Tightening Torque Table
Tightening Torque Table of Standard Parts BOLT (Nominal diameter) NUT (Nominal diameter) BOLT/NUT Normal screw Torque Nm (kg.m, Ib-ft) Nominal diameter...
Categories
- Manuals Home
- 3rd Generation i30 Owners Manual
- 3rd Generation i30 Service Manual
- Battery replacement
- To activate the ISG system
- Cruise control
- New on site
- Most important about car
Turn signals and lane change signals
To signal a turn, push down on the lever for a left turn or up for a right turn in position (A). To signal a lane change, move the turn signal lever slightly and hold it in position (B).The lever will return to the OFF position when released or when the turn is completed.
